1.0 OBJECTIVE
To check the performance of low temperature water bath for reliable and accurate results.2.0 SCOPE
This procedure is applicable to Low temperature water bath installed in Q.C.Dept.3.0 RESPONSIBILITY
3.1 Doing : Technical Assistant/Executive3.2 Checking : Executive /Manager
4.0 ACCOUNTABILITY
Head of the Department5.0 PROCEDURE
Frequency :Daily5.1 Operate the instrument as per respective standard operating procedure.
5.2 Fill D.M. water in water bath.
5.3 Switch ‘ON’ the mains.
5.4 Switch ‘ON’ the mains of instrument.
5.5 Set temperature 25°C using arrow key.
5.6 Observe the set temperature on display for 30 min. and record the results in Annexure-I
5.7 Repeat the procedure for three times.
5.8 Also note down the results with calibrated thermometer and record the results in Annexure-I.
5.9 If the performance of the instrument is satisfactory and set temperature obtained within limit, otherwise follow the S.O.P.
Related: SOP for Water Bath
6.0 ABBREVIATIONS
6.1 °C = Degree centigrade
ANNEXURE-I
PERFORMANCE CHECK REPORT OF LOW TEMPERATURE WATER BATH
Set temperature :________ Thermometer Id.No.__________
Acceptance criteria : + 0.2oC from set temperature
Date
|
Temperature on Dispaly
|
Observed temperature with
Calibrated thermometer
|
Done by
|
Checked by
| ||||
I
|
II
|
III
|
I
|
II
|
III
| |||
Get ready to use editable documents in MS-Word FormatView List
No comments:
Post a Comment
Please don't spam. Comments having links would not be published.